17 Comments

  1. Tick Talk on November 13, 2021 at 7:19 pm

    OK so the release lever on the lower grip just broke off



  2. s9xn9ne on November 13, 2021 at 7:20 pm

    very useful post thanks!



  3. Johnnie Red on November 13, 2021 at 7:22 pm

    None of my AK’s have a gap between the back of the receiver and stock that you mentioned. That is very unusual



  4. ComblocCustoms on November 13, 2021 at 7:23 pm

    Thanks.



  5. Denis E on November 13, 2021 at 7:25 pm

    Thanks. Very useful



  6. Thurnis Haley on November 13, 2021 at 7:27 pm

    Fuck Ironwood designs. Paid $250 for their stock and the fucking handguard split in two when trying to install it. I can’t just replace the piece, because they just happen to give me two pieces with really unique grain, so anything else is an obvious mismatch.



  7. Plox Plox on November 13, 2021 at 7:32 pm

    cant wait for APS set i just order in combloc red



  8. tro jansky on November 13, 2021 at 7:35 pm

    Looks nice but wayyy too expensive for less reliable materials (wood) than polymer!



  9. K on November 13, 2021 at 7:40 pm

    Quick tip: you should use a drill bit called a "brad-point" they’re made for wood and will give a much more accurate and clean hole. Those split-point bits are kind of tough to make sure they go exactly where you want them.



  10. hajikilla91 on November 13, 2021 at 7:41 pm

    #1 It’s sad U had to make this video, #2 That is the easiest Upper Handguard instillation / Removal I’ve ever seen..



  11. Doug Brown on November 13, 2021 at 7:41 pm

    Any vids for milled receiver install?



  12. Folgrin on November 13, 2021 at 7:50 pm

    I don’t understand why you leave a gap in the wood stock between the wood and rear trunnion



  13. Tick Talk on November 13, 2021 at 7:52 pm

    I don’t know what you did to get the bolt carrier group out but it just does not come out



  14. Sin Wai on November 13, 2021 at 7:54 pm

    ซื้อปืนตระกูลเอเคท่างหมด



  15. ComblocCustoms on November 13, 2021 at 8:01 pm

    Yes, sir. It was designed this way in order to prevent damage to the buttstock.



  16. JT Corvin on November 13, 2021 at 8:01 pm

    That wood is infuckingcredible.



  17. 12gaugeTim on November 13, 2021 at 8:04 pm

    So there will be a gap between the buttstock and the rear of the receiver?